♦ Exiting before completing part C:

We recommend that you finish parts A-C before stopping. If you cannot, we recommend that you exit ExamView without saving and start again from the beginning. To do this: 

1. If you are in the Question Bank Editor, i.e. before Part B, Step 3.

• Click on the File menu, then on Exit.

The following Caution dialog box will open.

• Click on No.

2. If the Question/Answer page is open.

• Click on Close.

The following Caution dialog box will open.

• Click on No.

Continue with 1 above (Click on the File menu, then on Exit…)

3. If the Edit Algorithms Definitions box is open –

• Click on Done.
• Continue with 2 above...

4. If the New Algorithm box is open

• Click on Cancel.
• Continue with 3 above..

♦ Exiting after completing part C

At the end of each of parts C, D, E, F and G you will be saving your work. This means that you can stop at the end of any of these parts without losing any of your work, and then start again by opening your file.

1. If you are at the end of a part, then you have just saved your work.

• Click on the File menu, then on Exit. 
• The program should just close (no dialog boxes should open).
• When you are ready to start again, go to Opening your Question bank/Test below.

2. If you are in the middle of a part and have to quit, follow the directions given above to exit without saving. You will lose the work from that part.

• When you are ready to start again, go to Opening your Question bank/Test below.

♣ Opening your Question bank/Test

• Start the ExamView Test Generatorgram on your computer.
• Click on the appropriate circle (see below). Then, click on OK.

• Open Tests dialog box: Click on the file name, then click on Open.

or

• Open Banks dialog box: Click on the file name, then click on Open.

• Double-click on the title.

The Title dialog box will open and you can make corrections.

(Note that if you start typing immediately, the current title will be erased! To edit, first click where you want to make a change.)

• Make your corrections, then click on OK.

Unless this really bothers you and you are familiar with file manipulation using the Microsoft Windows program My Computer or Windows Explorer, we recommend that you do nothing!

1. You can save your file under a different file name.

However, if you do this, you must delete the old file from within Windows.

This is because ExamView Test Generator works with bank and test names – not file names. So if you do not delete the old file, ExamView Test Generator will list two banks (or two tests) with the same name and you will not be able to tell them apart! To save under a different file name:

• Select the File menu, then Save As.

The Save As dialog box will open as in Part C, Step 6.

• Type the correct name for your file, then click on Save.

You can now delete your old file from within Windows.

or